CrossOver Support - Community Forums

Good evening,

How do you install crossover 18.5 with missing multiarch support error with Ubuntu Mate 19.10? Yes, I attempted to enable the support through the commandline.

Thanks,

I have the same issue with debian bullseye

Hi folks,

Just to start by covering the bases, have you tried the command:

sudo dpkg --add-architecture i386

Also, specifically for Ubuntu 19.10 (and perhaps the Debian version you are using as well?) you will need to use the .bin installer right now.*

Thanks,
Anna

*The upcoming CrossOver 19 will contain a fix that should allow the .deb installer to work again on new distros. It is a know issue, but Ubuntu 19.10 (and other affected distros like the newest Fedora) were released after CrossOver 18.5.

Yes, I have installed the i386 architecture with dpkg, but I have this when try to run the install with gdebi:

Reading package lists... Done
Building dependency tree
Reading state information... Done
Reading state information... Done
No se puede instalar este paquete
Dependency is not satisfiable: multiarch-support

when search for multiarch-support, the package is not listed (in debian bullseye)

Right. It sounds like you will need to use the .bin installer instead of the .deb installer+gdebi until CrossOver 19 is released. We have some instructions on installing the .bin installer here: https://www.codeweavers.com/support/docs/crossover-linux/install#install-mode

The multiarch-support package is missing on 19.10 repos. You need install manually.