CrossOver Support - Community Forums

Important Information These are community forums and not official technical support. If you need official support: Contact Us

CrossOver Linux
Discussion about CrossOver Linux

The following comments are owned by whoever posted them. We are not responsible for them in any way.

Back to Threads Reply to Thread

Installing unlisted application - Never ends

I recently installed crossover to allow me to use the windows program myheritage.

When I install it the program installs and runs fine and allows full functionality but when I look at the crossover window the status bar for Installing unlisted application is still scrolling back and forth even after an hour. If I exit the myheritage program then when I go back to crossover it isn't even listed as there.

Am I doing something stupidly wrong?

Thanks for any help,

I suggest that you try to install the program again, but when asked to run it, don't. This should finish the installation and close Crossover's installation window. Just after that, run the program for the first time. This is valid for all programs you may install with Crossover.

Please Note: This Forum is for non-application specific questions relating to installation/configuration of CrossOver. All application-specific posts to this Forum will be moved to their appropriate Compatibility Center Forum.

CrossOver Forums: the place to discuss running Windows applications on Mac and Linux

CodeWeavers or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in our Privacy Policy. You accept the use of cookies or other identifiers by clicking the Acknowledge button.
Please Wait...