CrossOver Support - Community Forums

Important Information These are community forums and not official technical support. If you need official support: Contact Us

CrossOver Linux
Discussion about CrossOver Linux

The following comments are owned by whoever posted them. We are not responsible for them in any way.

Back to Threads Reply to Thread

USB Programming Cable support

[404144.748879] usb-storage 7-4:1.0: USB Mass Storage device detected
[404144.749122] scsi host24: usb-storage 7-4:1.0
[404149.769174] scsi 24:0:0:0: Direct-Access STM microSD Flash 1.00 PQ: 0 ANSI: 2
[404149.770759] sd 24:0:0:0: Attached scsi generic sg6 type 0
[404149.797224] sd 24:0:0:0: [sdf] Attached SCSI removable disk
[404304.503901] usb 7-4: USB disconnect, device number 15
[404395.181498] usb 7-4: new full-speed USB device number 16 using ohci-pci
[404395.336144] usb 7-4: New USB device found, idVendor=0483, idProduct=5720
[404395.336149] usb 7-4: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[404395.336152] usb 7-4: Product: Mass Storage in FS Mode
[404395.336154] usb 7-4: Manufacturer: STMicroelectronics
[404395.336156] usb 7-4: SerialNumber: 00000000001B

This is not a usb-ser dev, an unmounted /dev/sdf resulted from above, but the installed programming software, could not find the radio. The cable by itself
is not detected.

Any tricks to get this working undder crossover? The comport dosdevices symlink trick does not apply here.

tux

You can try a "x::" (notice two ::) to /dev/sdf. Make sure /dev/sdf is read and writeable by your user. You'll probably also have to create "x:" (one colon) to point to a dummy directory.

I did try that earlier ( I think?) , as i saw the unmounted /dev/sdf & I tried with ::k symlink to /dev/sdf , but however the program did not recognise the connection.

I do have it all working fine in virtualbox, however crossover would have been more convienient.

Please Note: This Forum is for non-application specific questions relating to installation/configuration of CrossOver. All application-specific posts to this Forum will be moved to their appropriate Compatibility Center Forum.

CrossOver Forums: the place to discuss running Windows applications on Mac and Linux

CodeWeavers or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in our Privacy Policy. You accept the use of cookies or other identifiers by clicking the Acknowledge button.
Please Wait...
eyJjb3VudHJ5IjoiVVMiLCJsYW5nIjoiZW4iLCJjYXJ0IjowLCJ0enMiOi01LCJjZG4iOiJodHRwczpcL1wvbWVkaWEuY29kZXdlYXZlcnMuY29tXC9wdWJcL2Nyb3Nzb3Zlclwvd2Vic2l0ZSIsImNkbnRzIjoxNzI3NDcwNjA2LCJjc3JmX3Rva2VuIjoibmU1TFN4djluWVRGTjZTZiIsImdkcHIiOjB9