CrossOver Support - Community Forums

I've used Crossover before (years ago) and thought I'd give the new version a try to see if I can support some of our Windows only apps so we could migrate some of our computers to Linux. I installed the rpm on Fedora 11. When I go to the Install Windows Programs screen, however, the only clickable object is a GIANT cancel button. It doesn't appear I can do anything at all.

I've got an e-mail into Codeweavers, but since they've been slow to respond, I was wondering if anyone else had encountered this, and what the fix was, if so.

This sounds like http://www.codeweavers.com/support/wiki/CXOffice80_ButtonsGrayedOut

That article may help you get the interface back.

rando wrote:

I've used Crossover before (years ago) and thought I'd give the new
version a try to see if I can support some of our Windows only apps
so we could migrate some of our computers to Linux. I installed the
rpm on Fedora 11. When I go to the Install Windows Programs screen,
however, the only clickable object is a GIANT cancel button. It
doesn't appear I can do anything at all.

I've got an e-mail into Codeweavers, but since they've been slow to
respond, I was wondering if anyone else had encountered this, and
what the fix was, if so.

We've tracked down the email you sent us, and found that it was responded to approximately 8 hours after being sent. I apologize if you believe that this response time was inadequate. If you did not receive our email, please check your spam filter on the email address from which the message was sent. And of course, please let us know if the above wiki link (also included in our response email) did not help you solve the problem.

Thanks,
Jack